A L L parts are in San Diego! I have 427 parts including a rebuilt 1963 427 (2-bolt mount) short block. C3 heads and distributor and fuel pump. Have the dual quad top end, and a complete Tri-Power 3X2 manifold set-up. Have some mid-rise and Tunnel Port parts also. Have sold off the 289 hi-po parts. Lots of 351-C engine parts and some 351-W parts (including blocks). Have a couple of 200 6-cyl engines. Have a couple of rebuilt top loader transmissions and have the parts to rebuild about six (6) more. Have a couple of rebuilt T-10 transmissions, Mustang and Falcon/Comet/Ranchero. Have quite a few Mustang floor consoles, and a few parts to make a couple more! Have some sheet metal parts (not pictured). Have about five milk crates full of engine brackets and front engine pulleys. Have the knowledge to help you correct your pulley and bracket issues that NO ONE seems to be able to help you get corrected (in case you have been suffering with this)!! Can help you correct your car about that original air cleaner that is now missing. Have a 2' X 4' shelf of internal door parts. Hinges and latches with rods as well as original (tight) window regulators. Have some rear end center sections with different gears. Trac-loc units also. I have been rebuilding 8" and 9" third members (when I can make the time) for the past twenty years. Think about your needs and contact me about them. Also, these parts came from parted out cars from twenty + years ago. So, I am not needing to "retire on the sale of each part", so don't be shy. See attached pictures for ideas of parts still available.
Parts fit: Mustang , Cougar , Galaxie , Fairlane , Falcon , Ranchero , Torino
